AUTONET TV

Which Item Is Most Stolen from Vehicles in Clovis?

Which item is most often stolen from vehicles in Clovis?

Is it:

1. Stereo
2. Wheels
3. Air Bag
4. DVD System

Well, if you said stereo – you used to be right. But airbags have now surpassed stereos as the biggest target for theft in CA – approximately 50,000 a year are stolen across the country. New airbags cost about $1,000, but go for $50 to $200 on the black market in CA.

Stolen airbags are making their way back into cars that have been in an accident. Of course, the danger to the consumer of having a stolen airbag installed is that you can never be sure what may have previously affected them and if they will work right when you need them.

Contact us at Triple A Automotive for more information about where to get your airbags checked or replaced.
Find us at 972 Barstow Suite B, Clovis, CA 93612
You can reach us by phone at: (559) 299-9300

There are reports that 1 in 25 airbag replacements are stolen or salvaged airbags – or no airbag is installed at all.

That is definitely one car part you don't want to take a chance with, so Triple A Automotive recommends following these guidelines:

• Use a reputable collision repair center that employs ASE certified mechanics (we can offer recommendations at Triple A Automotive).

• Inspect the invoice to ensure that the repair shop purchased the airbag from a manufacturer, dealer or recycler. If you can inspect the airbag prior to installation, it should be packaged in a sealed container from the manufacturer.

• You will see the SRS light (Supplemental Restraint System) when you first start your vehicle up. This tells you that the airbag system is activated. If you do not see the SRS light, there is likely a problem with the airbag system.

Triple A Automotive
972 Barstow Suite B
Clovis, CA 93612
(559) 299-9300
http://www.tripleaautomotive.com

Clean Slate (Protecting Vehicle's Finish)

Winter is one of the hardest times to keep your vehicle clean. But did you know neglecting to wash your vehicle in winter could cost you a significant amount of money in the long run? Here's why.

Many areas deal with snow and ice in the winter, and the salt and sand that are used to keep the road surfaces from being slick are also super corrosive to a vehicle's metal body and undercarriage.  That includes all the parts underneath that can be splashed with brine, saltwater and other road debris.  Winter is also tough on vehicles where there isn’t snow, sometimes from ocean salt or winter's extra humidity and rain. 

If you have any breaks in your vehicle's paint, whether it be from a little fender bender or a stone chip, that corrosive winter moisture can get through those cracks and start eating away at the metal underneath. 

If you can, you should get any dents or damage fixed as soon as possible so your vehicle has a protective layer of paint between road chemicals and the metal.  You may want to wait until the warmer weather, but while you're waiting, the damage is getting worse.  If you're not sure of a reputable body repair shop, check with the service advisor where you have mechanical work done.  They're usually knowledgeable about who is good and not so good. 

You also may be tempted to skip the car wash during the winter since your vehicle is just going to get dirty fast anyway.  You may want to reconsider.  Many winter road treatments now use brine that gets in every nook and cranny of your vehicle.  It's wise to clean that off regularly during the winter, and many washing facilities include a spray underneath that gets rid of that salt.  Your vehicle repair facility may even have its own car wash, a nice bonus when you take your vehicle in for repair or regular maintenance. 

Triple A Automotive
972 Barstow Suite B
Clovis, CA 93612
(559) 299-9300
http://www.tripleaautomotive.com

Tire Tread Depth for Clovis, CA Drivers

Driving on bald tires is like playing roulette. Though you may be fine today, eventually your luck is going to run out.

The Feds don't have any laws for tread depth, but 42 of the states, and all of Canada, do have regulations. They consider 2/32 of an inch to be the minimum legal tread depth. Two other states, including California, consider 1/32 to be the minimum and six states have no standards at all. Call us at Triple A Automotive; (just call (559) 299-9300) to find out what your requirements are in the Clovis, CA, area.

Since 1968, U.S. law has required that a raised bar be molded across all tires. When tires are worn enough that this bar becomes visible, there's just 2/32 inch/1.6 mm of tread left. But does that older standard give Clovis vehicles enough safety?

Consider this: Consumer Reports recommends tire replacement when tread reaches 4/32 inch/3.2 mm. And the recommendation is backed by some very compelling studies. Now before we go into the studies, you need to know that the issue is braking on wet surfaces.

We tend to think of the brakes doing all the stopping, but Clovis vehicles also need to have effective tires to actually stop the car. When it's wet or snowy in Clovis, CA, the tread of the tire is critical to stopping power.

Picture this: you're driving in Clovis over a water-covered stretch of road. Your tires need to be in contact with the road in order to stop. That means the tire has to channel the water away so the tire is contacting the road and not floating on a thin film of water – a condition known as hydroplaning. When there's not enough tread depth on a tire, it can't move the water out of the way and you start to hydroplane.

This is where the studies come in. We think Clovis drivers will be surprised. A section of a test track was flooded with a thin layer of water. If you laid a dime flat on the track, the water would be deep enough to surround the coin, but not enough to submerge it. 

A car and a full-sized pick-up truck were brought up to 70 mph/112 kph and then made a hard stop in the wet test area. Stopping distance and time were measured for three different tire depths. First, they tested new tires. Then tires worn to legal limits. And finally, tires with 4/32 inch/3.2 mm of tread were tested (the depth suggested by Consumer Reports.)

When the car with the legally worn tires had braked for the distance required to stop the car with new tires, it was still going 55 mph/89 kph. The stopping distance was nearly doubled. That means if you barely have room to stop with new tires, then you would hit the car in front of you at 55 mph/89 kph with the worn tires.

Now with the partially worn tires – at the depth recommended by Consumer Reports – the car was still going at 45 mph/72 kph at the point where new tires brought the car to a halt. That's a big improvement – you can see why Consumer Reports and others are calling for a new standard.

Now without going into all the details, let us tell you that stopping the truck with worn tires needed almost 1/10 of a mile (.16 km)  of clear road ahead to come to a safe stop. How many Clovis drivers follow that far behind the vehicle ahead? Obviously, this is a big safety issue.

The tests were conducted with the same vehicles but with different sets of tires. The brakes were the same, so the only variable was the tires.

How do people in Clovis know when their tires are at 4/32 inch/3.2 mm? Well, it's pretty easy. Just insert an American quarter into the tread. Put it in upside down. If the tread doesn't cover George Washington's hairline, it's time to replace your tires. With a Canadian quarter, the tread should cover the numbers in the year stamp.

Now you may remember doing that with pennies. But an American penny gives you 2/32 inch/1.6 mm to Abraham Lincoln's head. The quarter is the new standard – 4/32 inch/3.2 mm.

Tires are a big ticket item, and most people in Clovis, CA, want to get thousands of miles/kilometers out of them. Just remember: driving on bald tires is like playing roulette.

Have Mr. Washington look at your tires today. If he recommends a new set, come see us at Triple A Automotive in Clovis.

Triple A Automotive
972 Barstow Suite B
Clovis, CA 93612
(559) 299-9300
http://www.tripleaautomotive.com

Go Straight: Wheel Alignment for Clovis Automobiles

Clovis drivers may have an alignment problem if their car drifts or pulls to one side, the steering wheel's off center, they notice uneven tire wear or the car doesn't feel like it handles right as they drive down Clovis, CA, streets and roads.

When all of a vehicle's wheels are lined up exactly with each other, your wheels are in alignment. Running into potholes, smacking a curb or other objects around Clovis are great ways to knock a car out of alignment. Then one or more of your wheels start pulling in a slightly different direction and the problems begin.

The team at Triple A Automotive in Clovis wants you to know that driving for an extended time when your car is out of alignment causes your tires to wear unevenly and excessively. Sometimes the tire can be worn so badly that it will fail.

At the very least, those who drive with wheels out of alignment will have to replace their tires sooner. You could end up with premature wear to your suspension system, which can be expensive. The front wheel alignment is adjustable on all vehicles, and the back wheels are also adjustable on some cars.

Now, let's discuss some alignment basics. Wheels are adjustable for toe, caster and camber. The ideal alignment for your car was designed by its engineers.

So, what is involved in an alignment check at Triple A Automotive in Clovis? First, there's an inspection of the steering and suspension to see if anything is bent or broken. Tire condition will also be evaluated.  Next, the vehicle is put on an alignment rack and we take an initial alignment reading.

If all four wheels are adjustable, they are lined up perfectly parallel with the vehicle's centerline. If the back wheels aren't adjustable, the direction they push is determined and the front wheels are aligned to match.

Like most things, vehicle manufacturers have recommended a mileage interval for having alignment checked. But if you run into a curb, pothole or something else that's given you a big jolt, pay attention to whether your vehicle is pulling to one side when you drive around the Clovis area. It's better for vehicle owners to have their alignment checked before waiting to see if there is uneven tire tread wear; by then, the damage is done.

Getting your alignment checked at Triple A Automotive when necessary is a great way to extend the life of your tires and suspension parts. It also makes sure that your tire meets the road properly for maximum performance and safety in CA.

Come see us at  for more information about your tire alignment. We look forward to serving you.

Triple A Automotive
972 Barstow Suite B
Clovis, CA 93612
(559) 299-9300
http://www.tripleaautomotive.com